Laserfiche WebLink
A. New signs. A new sign shall not be side of the sign face will not be <br /> erected, constructed, altered or main- counted additionally. The top <br /> tained except as herein provided and edge of any such freestanding <br /> until after a sign permit has been sign shall be not higher than fif- <br /> issued by the Building Inspector and teen (15) feet vertical measure <br /> the bond, if required, shall have been above the average level of the <br /> filed in accordance with Section 174- ground between the supports of <br /> 56. each sign. <br /> I <br /> B. Pre-existing signs in existence on (2) For building signs, square footage <br /> September 1, 1985 may continue. All shall be measured at the outside <br /> other signs must be permitted as perimeter of the sign board, if <br /> i required by this chapter. separately attached to the build- <br /> ing,or for signs consisting of sep- <br /> C. Any sign allowed under this chapter arately attached or painted letters <br /> may, in lieu of any specified copy, or symbols, as the maximum <br /> only identify the occupancy of such height of said letters or symbols <br /> premises or advertise the articles and times the maximum distance <br /> services available within said between the left side of the first <br /> premises, or contain any otherwise letter or symbol and the right side <br /> lawful, noncommercial message. In of the last letter or symbol. <br /> order to avoid public safety problems Signage on the reverse side of <br /> related to misdirection of emergency projecting signs will not be <br /> i response services, signage should, if counted additionally. Signs on <br /> possible, avoid duplication or avoid awnings shall be measured in the <br /> like sounding names of properties and same manner as separately <br /> business establishments. attached or painted letters or sym- <br /> bols, unless, in the opinion of the <br /> D. Alterations. A sign shall not be special permit granting authority, <br /> enlarged or relocated except in con- such awning is intended primarily <br /> formity with the provisions of this as an advertising device or sup- <br /> chapter for new sign permits or spe- port for said signage, in which <br /> cial permit modifications nor until a case the entire surface area of the <br /> proper permit has been secured. The awning will be counted as sig- <br /> changing of movable parts of an nage. <br /> approved sign that is designed for <br /> such changes, or the repainting or (3) Signs attached to walls and struc- <br /> reposting of display matter, shall not tures other than buildings shall be <br /> be deemed an alteration,provided that measured in the same manner as <br /> the conditions of the original approval building signs,unless,in the opin- <br /> and the requirements of this Article ion of the special permit granting <br /> are not violated. authority, or the Building <br /> Inspector for projects not involy- <br /> Dimensional measurement of signage. ing a special permit or a sign over <br /> twenty (20) square feet, such wall <br /> (1) For freestanding signs, square or structure is intended primarily <br /> footage shall be measured at the as an advertising device or sup- <br /> outside perimeter of the structure port for said signage, in which <br /> on which the sign is located, case the entire surface area of the <br /> exclusive of the portion of any wall or structure will be counted <br /> supporting posts or similar struc- as signage." <br /> ture below the lower edge of the <br /> sign face. Signage on the reverse <br /> 79 <br />